• How to use the automatic spray gun to spray the best atomization effect?

    How to use the automatic spray gun to spray the best atomization effect?

    When most sprayers use automatic spray guns to spray, they only teach themselves by the way the master teaches the disciples. There is no clear calculation formula to express, only the experience that can be derived slowly from every failure. Once a technical expert from an Italian spray gun manufac... read more

    Apr 28,2020 Industry News
  • How to operate the spray gun safely?

    How to operate the spray gun safely?

    1. Purpose Through standardized operating procedures, to ensure that the processed workpieces meet the quality requirements, to avoid accidents caused by irregular operations. 2. Adaptation range 3. Homework preparation (1) Clean the spray gun and paint; (2) Check for leaks in the gates of the air p... read more

    Apr 22,2020 Industry News
  • What type of spray gun is mainly used?

    What type of spray gun is mainly used?

    The furniture is normal, we choose the traditional spray gun, caliber 1.3, 1.5 these two are most suitable. The spray gun is divided into the upper pot and the lower pot. The environmental protection and the traditional pot spray gun are more paint-saving, and the lower pot spray gun is more labor-s... read more

    Apr 16,2020 Industry News
  • What to pay attention to when choosing an automatic spray gun

    What to pay attention to when choosing an automatic spray gun

    When choosing an automatic spray gun, it is necessary to consider that the primer will mainly fill the gaps in the coating and increase the thickness of the coating. Therefore, the primer has a large particle size, a large viscosity, and a large specific gravity. It emphasizes that the amount of pai... read more

    Apr 08,2020 Industry News
  • Common problems of spray guns and some solutions (2)

    Common problems of spray guns and some solutions (2)

    Spray splitting Reasons: (1) The paint viscosity is too low; (2) The spray pressure is too high; (3) The inner diameter of the fan control hole is too large; (4) The paint is insufficient; (5) The atomizing air passage is blocked. Solution: (1) Increase paint viscosity (2) Reduce spraying pressure (... read more

    Apr 02,2020 Industry News